WIP

Selected components

Requirements

0.1.0 development

  1. Photovoltaic input
    1. Connector
      1. (req) The connector must be a 4 pin dual-row Molex micro-fit 43045 or compatible type
    2. Electrical
      1. (req) Input voltage range at least 10-24V
      2. (req) PV reverse polarity protection
      3. (req) PV transient protection > 100V
      4. (req) PV overvoltage protection > 24V
      5. (req) PV overcurrent protection (passive)
  • (req) 8 pin battery connector
  • (req) bat reverse polarity protection
  • (req) bat transient protection
  • (req) bat overcurrent protection (passive)
  • (req) bat overcurrent secondary protection (active)
  • (req) 5V/4A backplane low-power bus output
  • (req) smbus interface
  • (adv) can interface
  • (adv) 5V/2A USB output
  • (adv) 10-24V AC adaptor input (disconnects PV input)
  • tsp-2e-nwr2u/2-cell-tsp-solar-power-board-2u-nwr-form-factor.txt
  • Last modified: 2019/11/19 01:34
  • by qyx